What is the problem? What did you already try to solve it? Additional information about your setup OctoPrint version, OctoPi version, OctoPrint 1. I am very new to Raspberry and Linux, for that reason, I can not offer logs files as I dont know how to collect the ones which are needed for my problem.
I have installed Octoprint on my Raspberry 3 and connected a Logitech C camera to it. Everything worked perfect, but since I upgraded my Octoprint Version to 1.
It's located at a different place than octoprint. I call my multiprinter solution not octofarm anymore because there were allready many projects called octofarm and i don't want to be sued. Thank you very much for your help. I have no idea, what I was thinking that time! Unfortunately, I have the same problem again. Only used octopi just a few times. On my own rig, the Smoothieboard and the PyBoard change places all the time in the device tree.
Creating udev rules as discussed earlier is the best way to tackle this "musical chairs" problem. That's normal and expected. Any configuration files would then need to point to this rather than whatever it was before. OctoBooster March 31, , am 1. Camera model Logitech C What is the problem? Tried to set parameters in octopi.
I would be very happy, if someone with more experience could help me with that problem. Many thanks and best regards, Tim. Try clicking on any one of the four links that say "logs" in your post. Compton March 31, , pm 3. OctoBooster March 31, , pm 4. Hello foosel, here is the octoprint logfile and syslog logfile.
